Tricopter

This slideshow requires JavaScript.

I designed the base of the tricopter using Google Sketchup then exported it to SVG for Inkscape. Using the Inkscape files I had the design laser cut and shipped to me by Ponoko.com. You can get your own cut out of various materials from my Ponoko showroom. The total to have it cut and shipped was $28.53 for 5mm birch plywood.
For control Ill be using a Spectrum DX7 radio and a KK Multicopter controller.

The design is based on this one from rcexplorer.se

I updated the pictures showing some progress. It will fly but I haven taken it outside yet because of the weather. Snow and the electronics don’t mix if it crashes. Until the weather improves, a couple inches off the ground in the living room will have to do. I still need to mount the battery better, isolate the board from vibration, and balance it it out for best performance.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s